Belt up and enjoy this 365-day ride as you cruise past the most momentous motoring events in history. Packed with fascinating facts about races, motorists and the history of the mighty engine, this is a must-visit web site for any car enthusiast.
The Austin-Healey ‘Frogeye’ Sprite was announced to the press by BMC in Monte Carlo, just before the start of that year’s Monaco Grand Prix. Designed by the Donald Healey Motor Company, which received a royalty payment from manufacturers BMC, it was intended to be a low-cost model (£669) that ‘a chap could keep in his bike shed’. The Sprite quickly became affectionately known as the "frogeye" in the UK and the "bugeye" in the US, because its headlights were prominently mounted on top of the bonnet, inboard of the front wings. The car's designers had intended that the headlights could be retracted, with the lenses facing skyward when not in use; a similar arrangement was used many years later on the Porsche 928. But cost cutting by BMC led to the flip-up mechanism being deleted, therefore the headlights were simply fixed in a permanently upright position, giving the car its most distinctive feature. The body was styled by Gerry Coker, with subsequent alterations by Les Ireland following Coker's emigration to the US in 1957. The car's distinctive frontal styling bore a strong resemblance to the defunct American 1951 Crosley Super Sport. 48,987 "frogeye" Sprites were made. The problem of providing a rigid structure to an open-topped sports car was resolved by Barry Bilbie, Healey's chassis designer, who adapted the idea provided by the Jaguar D-type, with rear suspension forces routed through the bodyshell's floor pan. The Sprite's chassis design was the world's first volume-production sports car to use unitary construction, where the sheet metal body panels (apart from the bonnet) take many of the structural stresses. The original metal gauge (thickness of steel) of the rear structure specified by Bilbie was reduced by the Austin Design Office during prototype build, however during testing at MIRA (Motor Industry Research Association) distortion and deformation of the rear structure occurred and the original specification was reinstated. The two front chassis legs projecting forward from the passenger compartment mean the shell is not a full monocoque. The front sheet-metal assembly, including the bonnet (hood) and wings, was a one-piece unit, hinged from the back, that swung up to allow access to the engine compartment. The 43 bhp, 948 cc OHV engine (coded 9CC) was derived from the Austin A35 and Morris Minor 1000 models, also BMC products, but upgraded with twin 1 1⁄8 inch SU carburettors. The rack and pinion steering was derived from the Morris Minor 1000 and the front suspension from the Austin A35. The front suspension was a coil spring and wishbone arrangement, with the arm of the Armstrong lever shock absorber serving as the top suspension link. The rear axle was both located and sprung by quarter-elliptic leaf springs, again with lever-arm shock absorbers and top links. There were no exterior door handles; the driver and passenger were required to reach inside to open the door. There was also no boot lid, owing to the need to retain as much structural integrity as possible, and access to the spare wheel and luggage compartment was achieved by tilting the seat-backs forward and reaching under the rear deck, a process likened to potholing by many owners, but which resulted in a large space available to store soft baggage. Engine: 1958–1961: 948 cc A-Series I4, 43 hp (32 kW) at 5200 rpm and 52 lbf·ft (71 Nm) at 3300 rpm A car was tested by the British magazine The Motor in 1958. It had a top speed of 82.9 mph (133.4 km/h) and could accelerate from 0-60 mph (97 km/h) in 20.5 seconds. Fuel consumption of 43 miles per imperial gallon (6.6 L/100 km; 36 mpg‑US) was recorded. The test car cost £678, including taxes of £223. The BMC Competition Department entered Austin Healey Sprites in major international races and rallies, their first major success coming when John Sprinzel and Willy Cave won their class on the 1958 Alpine Rally. In 1959, the Sprite was introduced to the U.S. market by racing and winning its class in the 12-hour race at Sebring. Private competitors also competed with much success in Sprites. Because of its affordability and practicality, the Austin Healey Sprite was developed into a formidable competition car, assuming many variants by John Sprinzel, Speedwell and WSM. The Sebring Sprite became the most iconic of the racing breed of Austin Healey Sprites. Many owners use their Austin Healey Sprites in competition today, fifty years after its introduction.