How to Change Oil in A Car: A Step By Step Guide

Performing regular oil changes in your car has a lot of benefits. For instance, it improves the efficiency of your engine by keeping it clean. It will also improve your car’s mileage in the long run. With higher efficiency comes a longer engine lifespan, and changing engine oil will make your vehicle more environmental-friendly since the car will release fewer emissions into the atmosphere. Changing the oil in your car regularly will help cool off the car’s engine, and your car will pass emission tests constantly.

How to Change the Oil in Your Car- Step by Step

Perhaps the quickest and most efficient way of changing your car oil is to get the help of a reputable auto technician. You can get it done from Tedious Repairs, a reliable auto shop where all kinds of maintenance servicing and auto repairs are carried out with a guaranty. Though you can also change the oil in your car by yourself, it may take you more time than having a professional auto mechanic handling such.

The first step is to jack up and open up the car. Make sure the car is high enough to give you enough space. You can use a hoist, jack stands, or ramps for this purpose. Some modern cars come with plastic under-trays, making sure you have easy and safe access to the oil pan and filter. Make sure you also examine the region for any leakages of oil.

The second step is to unplug and drain the oil.   It would be best to get your oil receptacle; first, this could be the 5-gallon bucket or oil draining pan. This will collect the oil being drained and prevent it from reaching the ground. Most cars will have at least 1 gallon of oil in their crankcase; hence you must be prepared to collect a lot of oil. Loosen the drain plug with a wrench and in a counter-clockwise motion. Hold on to the drain plug while you remove it, and the oil will pour out as you pull away from the oil pan. Allow the oil to drain until it starts trickling.

The next step is to locate and remove the old oil filter, which is the soft-ball-sized cylindrical component screwed to the engine. Use a filter wrench or your hand to loosen the filter and allow the oil to run out unto your oil collector. Let the oil flow slow down entirely until you stop removing the filter. Ensure the old gasket is removed after draining the oil because a new filter wouldn’t seal properly. You must wipe down any surface covered with old oil before replacing the drain plug and oil filter.

The fourth step is to drain the plugin and add the new filter. Tighten the drain plug until it becomes snuggly. You can use a torque wrench for tightening but avoid ripping off the plug’s head. Take the new oil filter and apply a slight oil coating of oil on the rubber gasket located on the top of the filter. This will help create a good seal as you tighten your new filter. Screw the filter in and make sure it is snuggly tight.

The fifth step is to fill your car back up with new oil. Ensure you re-install the under-tray and lower the vehicle back to the ground level once you replace the oil filter and drain plug. Just open the hold and then remove the oil cap. With the aid of a funnel, fill the car engine with the recommended oil only.

You must check the oil level and possible leaks before completing this task. Please wait for a little for the oil to settle into the pan, then pull the dipstick away from its tube and wipe out the oil on the stick with a clean paper towel before re-inserting the dipstick. You must confirm that the oil reaches the required marking on the dipstick, and if not, you may have to add more oil until the mark is reached.

Start your vehicle and let it warm up while idle. Make sure you check once again for leaks around the filter and under your car.

Leave a Reply

Your email address will not be published. Required fields are marked *